Estlcam svg11/27/2023 I think I did find a bug in Easel, I just need to get the case down better before I do the report. Even if there is a default, I think you should always write a G20 or G21 depending on the units, it is best not to depend on anyone else for that. Here is the actual output from the easel post processor from Vectric. What are the default length and feed units? Easel supplies the spindle control although you can also set the specific spindle speed if needed through M3 SXXX at the beginning and end. Can you post the gcode you exported? Do you know if it supports post processors? Here is the spec for what Easel needs. Continuing the discussion from G-code sending through easel.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |